Finite Element Analysis for the Prediction of Durability of Idler Wheel of Tracked Vehicle

Lee, Kyoung-Ho; Roh, Keun-Lae; Lee, Young-Shin

Journal of the Korea Institute of Military Science and Technology 2009;12(5):676-682.

Kyoung-Ho Lee, Keun-Lae Roh, Young-Shin Lee

¹
²ChungNam National University

궤도차량용 휠의 내구성 예측을 위한 유한요소 해석 기법 연구

이경호, 노근래, 이영신

¹국방과학연구소
²충남대학교

Abstract

The idler wheel installed at the front side of the newly developed tracked vehicle didn't meet the durability requirement by showing the crack failure near the jointed region at the wheel during the field test. To find the crack developing mechanism we constructed finite element model for the idler wheel representing the behavior of interface between each suspension units, material properties from the material test data and actual loading conditions. This paper shows a result that maximum von Mises stress near the bolt hole on the outer rim is higher than inner idler coressponding to the actual test result and that result was reversed by adopting the reinforcement outside of the outer rim.

Key Words: Idler Wheel, Track Tension, Contact, Durability