J. KIMS Technol Search

CLOSE


J. KIMS Technol > Volume 20(3); 2017 > Article
Journal of the Korea Institute of Military Science and Technology 2017;20(3):352-361.
DOI: https://doi.org/10.9766/KIMST.2017.20.3.352   
A Design and Fabrication of Test Equipment for Airborne Tracking Radar Test
Seung-Gu Yoon, Seung-wook Park, Jun-Bum Kwon, Man-Seek Jung
1ISR & EW R&D Center, LIG NEX1 Co., Ltd.
2The 3rd Research and Development Institute, Agency for Defense Development
항공기용 추적레이더 시험을 위한 시험장비의 설계 및 제작
윤승구, 박승욱, 권준범, 정만식
1LIG넥스원(주) 감시정찰연구소
2국방과학연구소 제3기술연구본부
Abstract
This paper proposes a design and fabrication of the test equipment that is implemented as a part of the airborne tracking radar inspection under the environment of indoor simulation. This test equipment provides controlling the operation status of airborne tracking radar and replicating the velocity and range information of target by generating a variety of target signal. This is mainly composed of radar operation controller, target signal generator, horn antenna driving devices. Radar operation controller is able to perform the controlling of radar operation mode and monitoring in real time by serial communication. Target signal generator is generated doppler signal and range delayed signal using virtual target of RF-band. Horn antenna driving devices perform a role of target simulating exercise. In the end, the performance is demonstrated using experiment results of test equipment for airborne tracking radar.
Key Words: Airborne Tracking Radar, Radar Operation Controller, Target Signal Generator, Horn Antenna Driving Devices


ABOUT
ARTICLE CATEGORY

Browse all articles >

BROWSE ARTICLES
FOR CONTRIBUTORS
Editorial Office
160 Bugyuseong-daero 488beon-gil, Yuseong-gu, Daejeon 34060, Korea
Tel: +82-42-823-4603    Fax: +82-42-823-4605    E-mail: kimst@kimst.or.kr                

Copyright © 2024 by The Korea Institute of Military Science and Technology.

Developed in M2PI

Close layer
prev next